00 Maintenance Jobs - 1972 through 1980
Introduction
- 1972-1974
- Maintenance Manual USA Model Year 1972-1980 Passenger Cars
Volume 1
- 1975-1976
- Maintenance Manual USA Model Year 1972-1980 Passenger Cars
Volume 1
- 1977-1979
- Maintenance Manual USA Model Year 1972-1980 Passenger Cars
Volume 1
- 1980-1980
- Maintenance Manual USA Model Year 1972-1980 Passenger Cars
Volume 1
- 009 - Check
brake cables for ease of movement
- 020 - Hydro-pneumatic
suspension Check rubber sleeves of ball joints on tube
shocks
- 023 - Check
sealing of comfort hydraulic system for leaks and condition
- 025 - Check
play of steering as well as play and condition of steering linkage
- 028 - Checking
front axle joints for condition and leaks for rubber sleeves
- 030 - Check
joint discs on propeller shaft
- 038 - Check
cooling and heating system for leaks
- 041 - Check
sealing and condition of fuel system
- 045 - Check
clutch operating mechanism for leaks and condition
- 085 - Check
sealing and condition of level control system
- 086 - Hydro-pneumatic
suspension Check system for leaks and condition
- 087 - Check
condition of air suspension system
- 097 - Brake
test on dynamometer/Test drive
- 098 - Test
drive
- 099 - Functional
check
- 101 - Check
and correct fluid level in oil bath air filter
- 120 - Check
and correct fluid level in automatic transmission
- 121 - Check
and correct fluid level in manual transmission
- 130 - Check
and correct fluid in rear axle
- 134 - Check
and correct fluid level of power steering
- 135 - Check
and correct fluid level in mechanical steering
- 138 - Check
and correct fluid level in level control system
- 139 - Hydro-pneumatic
suspension -- Check and correct fluid level
- 151 - Engine
oil and filter change
- 156 - Clean
supplementary oil filter for hydraulic fan coupling
- 170 - Oil
change, automatic transmission
- 171 - Oil
change, manual transmission
- 174 - Replacing
filter for automatic transmission
- 180 - Oil
change, rear axle
- 202 - Clean
air filter element
- 203 - Replace
air filter element
- 205 - Clean
oil bath air filter
- 250 - Grease
front and rear axles
- 350 - Lubricate
door hinges
- 375 - Lubricate
outside mirror
- 388 - Renew
grease in hub-caps in front wheel bearing
- 393 - Lubricate
door locks
- 395 - Lubricate
engine hood
- 415 - Lubricate
engine control linkages and control shafts
- 463 - Check
and correct fluid level in the anti-freeze device of the air
suspension system
- 465 - Check
fluid level of screen washer unit
- 466 - Drain
condensation from air reservoir of air suspension
- 470 - Renew
air filter of air suspension system
- 484 - Check
fluid of air conditioning system
- 494 - Check
fluid level of comfort hydraulic system
- 497 - Replace
perlon filter in fan wheel (front heater box)
- 498 - Replace
perlon filter in magnetic valve of heater
- 501 - Check
wear on the clutch driven plate
- 510 - Check
and correct fluid level of the clutch operation
- 622 - Check
level of vehicles with air suspension (position of wishbone arms
on front axle and rear wheel camber)
- 625 - Check
toe-in of front wheels
- 628 - Hydro-pneumatic
suspension Check pressure reservoir and central reservoir
for gas filling pressure
- 630 - Adjust
wheel bearing end play on front axle
- 631 - Renew
grease charge on front wheel bearing, check tapered roller bearing
- 650 - Adjusting
of detent for rear axle carrier
- 676 - Check
air bellows of air suspension system
- 700 - Check
and correct fluid level in the brake system
- 701 - Bleed
brake system
- 702 - Renewing
brake fluid
- 703 - 703
707 708 - 709
- 704 - Checking
oil level in vacuum pump
- 706 - Adjust
parking brake
- 711 - Front
wheel brake Visual checkup of brake pads
- 712 - Check
and clean disc brakes, remove brake pads for this purpose
- 713 - Clean
ventilation bores on the compressed air brake booster
- 714 - Check
brake lines for damage
- 751 - Check
compression
- 752 - Retighten
cylinder head bolts
- 753 - Adjust
valve clearance
- 756.1 -
Retension V-belts
- 756.2 -
Retension V-belts (cont'd)
- 756.3 -
Retension V-belts (cont'd)
- 757 - Check
condition and tension of V-belts
- 758 - Check
condition and retension V-belts
- 759 - Slacken
engine stop and tighten screws
- 760 - Slacken
engine stop
- 762 - Clean
flame guard filament
- 763 - Clean
exhaust gas recycling
- 764 - Check
fuel evaporation system in engine compartment
- 765 - Check
air injection
- 766 - Clean
throttle valve
- 767 - Replace
catalyst
- 768 - Oxygen
sensor replacement
- 770 - Renew
spark plugs
- 771 - Check
spark plugs, replace if necessary
- 772 - Check
and adjust ignition timing
- 773 - Renew
contact breaker points
- 774 - Check
ignition change-over
- 776 - Check
on-off ratio, adjust if necessary
- 781 - Check
dwell angle
- 782 - Adjust
dwell angle and ignition timing
- 785 - Check
and lubricate heater flaps
- 787 - Check
beginning of delivery
- 788 - Check
and fill up oil level in damper of Stromberg carburetor
- 793 - Check
idling speed stabilization
- 796 - Check
throttle valve lift / Coasting conditions
- 797 - Check
and adjust idle speed adjustment
- 798.1 -
Check and adjust idle speed
- 798.2 -
Check and adjust idle speed and idle CO
- 799 - Check
idle speed, adjust if necessary
- 800 - Check
and adjust oil level in injection pump
- 806 - Replace
filter of auxiliary air valve of the injection pump
- 813 - Check
engine control linkage
- 821 - Check
acid level of battery
- 832 - Check
condition of ignition system / Evaluate oscillograph picture
- 840 - Replace
fuel filter or filter element
- 844 - Check
fuel prefilter
- 845 - Clean
or replace fuel main filter
- 847 - Clean
/ replace fuel filter
- 849 - Replace
fuel filter element
- 851 - Clean
strainer in the fuel pump
- 852 - Renew
strainer in the fuel pump
- 871 - Check
intake and exhaust manifolds and exhaust flange for tight fit
- 876 - Retighten
carburetor flange
- 877 - Retighten
nuts on exhaust gas turbocharger
- 891 - Check
fuel pipes and hoses of the electronically controlled gasoline
injection unit for tight fit
- 895 - Check
attachment of alternator
- 902 - Retighten
fixing bolts of the air compressor
- 905 - Retighten
bolts and nuts on the refrigerant compressor support
- 907 - Check
hose clamps for tight fit
- 920 - Retighten
bolts and nuts for power steering pump and support
- 922 - Retighten
fastening bolts of bearing pins for lower control arm of front
axle
- 924 - Retighten
steering fastening bolts
- 951 - Retighten
exhaust system slip joints
- 982 - Check
tires, if required interchange wheels
- 983 - Removing
and fitting wheels, checking rims
- 987 - Correct
tire pressure
- 988 - Retighten
spherical collar bolts on wheels
- 990 - Check
and correct coolant level
- 991 - Renew
coolant together with antifreeze
Back to 00 Maintenance
Copyright © 2003, 2004 Steve Nervig.
All
Rights Reserved